Crown Victoria V8-4.6L (2009)
Brake Master Cylinder: Removal and Replacement
Brake Master Cylinder
Brake Master Cylinder
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Disconnect the brake tube fittings from the master cylinder.
-
To install, tighten to 17 Nm (150 lb-in).
2. Disconnect the brake fluid level switch connector.
3. Remove the 2 brake master cylinder nuts.
-
To install, tighten to 23 Nm (17 lb-ft).
4. Remove the wiring harness bracket and position aside.
