Crown Victoria V8-4.6L (2009)
5. NOTE: Lubricate the inner lip of the crankshaft rear seal with engine oil.
Using the Crankshaft Rear Oil Seal Installers, install the crankshaft rear seal.
6. Using the Crankshaft Rear Oil Slinger Installer and Crankshaft Rear Oil Seal Installers, install the crankshaft oil slinger.
7. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Inspect the oil pan. Clean the mating surface for the oil pan with silicone gasket remover and metal surface prep. Follow the directions on the
packaging.
8. Position the oil pump screen and pickup tube in the oil pan and position the oil pan and new gasket into the vehicle.
9. NOTICE: Make sure to install a new O-ring seal. A missing or damaged O-ring seal may cause foam in the lubrication system, low oil
pressure and severe engine damage.
NOTE: Clean and inspect the mating surfaces and install a new O-ring seal. Lubricate the O-ring seal with clean engine oil prior to installation.
Position the oil pump screen and pickup tube and install the bolts.
-
Tighten the oil pump screen and pickup tube-to-oil pump bolts to 10 Nm (89 lb-in).
-
Tighten the oil pump screen and pickup tube-to-spacer bolt to 25 Nm (18 lb-ft).
10. NOTICE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use
silicone gasket remover and metal surface prep. Follow the directions on the packaging. Failure to follow this procedure can cause future
oil leakage.
Apply silicone gasket and sealant at the rear seal retainer-to-cylinder block sealing surface.
11. NOTICE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use
