Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
4. Remove the disc brake caliper.
1
Remove the disc brake caliper bolts.
2
Lift the disc brake caliper off the front disc brake caliper anchor plate.
5. Inspect the disc brake caliper.
-
If leaks or damaged boots are found, disassembly is required.
Installation
1. CAUTION: Make sure guide pin boots are properly seated or damage to guide pins can occur.
NOTE: Tighten the lower caliper bolt first.
Install the disc brake caliper.
1
Install the disc brake caliper.
2
Install the disc brake caliper bolts.
2. Install the front brake hose.
-
Use new copper washers; connect the front brake hose.
-
Install the front brake hose bolt.
3. Bleed the caliper.
4. NOTE: After the vehicle is on the ground, if equipped with air suspension, reactivate the system by turning on the air suspension switch.
Install the wheel and tire assembly.
5. Fill the brake master cylinder reservoir with clean High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent DOT 3 fluid meeting
