Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
Key Warning Switch: Service and Repair
REMOVAL
1. Remove the ignition lock cylinder.
1
Insert the key into the ignition key and turn to the RUN position.
2
Insert a punch in the access hole of the steering column and press the release tab while pulling out the ignition switch lock cylinder.
2. Remove the key-in-ignition warning switch.
1
Release the clip.
2
Push the key-in-ignition warning switch off the rear of the ignition switch lock cylinder.
INSTALLATION
1. To install, reverse the removal procedure
^
Verify ignition lock cylinder operation.
