Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
Lamp Control Module: Service and Repair
REMOVAL
CAUTION: Prior to removal of module, it is necessary to upload module configuration information to New Generation STAR (NGS) Tester. This
information needs to be downloaded into the new module once installed.
1. Disconnect the battery ground cable.
CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
2. Remove the LH instrument panel lower insulator.
1
Remove the pin-type retainers.
2
Disconnect the courtesy lamp.
3
Remove the LH instrument panel insulator.
3. Position the LCM aside.
1
Remove the locking tab.
2
Release the locking tab.
3
Position the LCM aside.
4. Remove the LCM.
1
Disconnect the electrical connectors.
2
Remove the LCM.
INSTALLATION
1. To install, reverse the removal procedure.