Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
Multifunction Electronic Control Module: Service and Repair
Driver Door Module
REMOVAL
CAUTION: Prior to removal of module, it is necessary to upload module configuration information to New Generation STAR (NGS) Tester. This
information needs to be downloaded into the new module once installed.
1. Disconnect the battery ground cable.
CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damages may result.
2. Remove the driver door trim panel.
3. Remove the Driver Door Module (DDM).
1
Disconnect the electrical connector.
2
Remove the screws.
3. Release the locking tab.
INSTALLATION
CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the New Generation STAR
(NGS) Tester into the new module.
1. To install, reverse the removal procedure.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
