Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
Brake Pad: Service and Repair
Rear
Removal
1. Inspect the brake pads for wear or contamination. Install new if worn to or past specification.
2. NOTE: It is not necessary to remove the rear wheel brake hose when performing this procedure.
Remove the rear disc brake caliper.
3. CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the brake pads.
Remove the brake pads by pushing inward and rotating the pad up.
4. NOTE: Use a block of wood or used pad to protect the piston and boots.
Retract the caliper piston into the rear disc brake caliper.
