Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
1
Scribe a mark into the threads on the tie-rod end where shown.
2
Loosen the nut and bolt.
3
Remove the tie-rod end.
Installation
1. NOTE: Do not tighten the clamp on the front wheel spindle tie-rod adjusting sleeve until the front wheel alignment has been checked.
NOTE: Both the left side and the right side outer tie-rod ends are installed the same way. Only the left side is shown.
Install the tie-rod end into the front wheel spindle tie-rod adjusting sleeve.
2. Install the tie-rod end, nut and a new cotter pin.
3. Lower the vehicle.
4. Check the wheel alignment. Adjust as necessary.
