Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
Compressor/Pump: Service and Repair
Removal
WARNING: Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components
supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal
injury.
WARNING: Disconnecting an air line that is connected to the air compressor can cause personal injury or damage to components as high
pressure air is vented uncontrolled.
WARNING: Before performing maintenance on any air suspension components, disconnect the power to the system by turning off the air
suspension switch located on the LH side of the luggage compartment to prevent vehicle damage or personal injury.
1. Turn the air suspension switch off.
2. Disconnect the battery ground cable.
3. Remove the Engine Air Cleaner (ACL).
4. Remove the air compressor and air compressor drier cover.
1
Remove the pushpins.
2
Remove the air compressor and air compressor drier cover.
5. Remove the snorkel pushpin and remove the snorkel.
6. Remove the air compressor and air compressor drier.
1
Compress the quick connect locking ring and pull out the air line.
2
Disconnect the electrical connector.
3
Remove the three bolts.
