Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
1. Install the extension housing and gasket.
1. Position the extension housing gasket and the extension housing.
2. Install the bolts and the nuts.
2. Install the new extension housing seal.
1. Align Extension Housing Seal Replacer with the seal.
2. Install the extension housing seal.
3. Raise and position the transmission.
4. Install the transmission crossmember.
1. Position the transmission crossmember.
2. Install the bolts.
5. Remove High-Lift Transmission Jack.
6. Install the two transmission mount nuts.
NOTE: The output shaft and the drive shaft are a balanced assembly.