Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
2. Tighten the Threaded Drawbar to seat the pinion bearing cups into their bores.
3. Drive the outer pinion bearing cup into the axle housing using the special tools.
4. Drive the inner pinion bearing cup into the axle housing using the special tools.
CAUTION: Whenever the cups are replaced, the pinion bearings must also be replaced.
NOTE: If a feeler gauge can be inserted between a cup and the bottom of its bore at any point around the cup, the cup is not correctly seated.
5. Make sure the cups are correctly seated in their bores.
NOTE: Apply only a light oil film on the pinion bearings before assembling the tool.
