Crown Victoria V8-4.6L Flex Fuel (2008)
Part 2
Removal and Installation
1. WARNING:
-
Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire
Suppression System. Failure to follow the instructions may result in serious personal injury.
-
Shut off the electrical power to the air suspension system prior to hoisting or jacking an air suspension equipped vehicle. Failure to do
so may result in unexpected inflation or deflation of the air springs, which may result in shifting of the vehicle during these operations.
Failure to follow this instruction may result in serious personal injury.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 lower radiator air deflector bolts and the 2 radiator vertical deflector bolts.
-
To install, tighten to 7 Nm (62 lb-in).
3. Remove the 2 pin-type retainers (1 each side).
4. Remove the 6 front bumper cover pin-type retainers (3 each side).
5. Remove the side turn signal lamp assemblies.
6. Remove the 2 front bumper cover screws (1 each side).
-
To install, tighten to 7 Nm (62 lb-in).
7. Remove the 2 front bumper cover-to-fender screws (1 each side).
-
To install, tighten to 2 Nm (18 lb-in).
8. If equipped, disconnect the fog lamp electrical connectors and remove the front bumper cover.
9. To install, reverse the removal procedure.
