Crown Victoria V8-4.6L Flex Fuel (2008)
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Driver side shown, passenger side similar.
All seats
1. Position the front seat to access the fasteners.
2. Depower the SRS.
3. Remove the front seat.
Passenger seat with OCS
4. To disassemble a passenger seat cushion equipped with an occupant classification sensor (OCS) system, remove the OCS.
All seats
5. Remove the front seat backrest.
6. Remove the seat track.
Seat with power lumbar
7. NOTE: Take care when removing the power lumbar bezel. Pry the side of bezel at tabs to remove.
Remove the power lumbar switch bezel.
8. Disconnect the lumbar switch electrical connector.
All seats
9. Release the cushion trim cover retainers.
1
Release the J-clips.
2
Remove the pin-type retainer.
Heated seats
10. Disconnect the cushion heater mat electrical connector.
11. Disconnect the heated seat module electrical connector.
12. Insert a flat-blade screwdriver into the heated seat module bracket and release the locking tab. Remove the heated seat module.
