Crown Victoria V8-4.6L Flex Fuel (2008)
9. Remove the steering column shaft bolt and disconnect the steering column shaft from the steering column.
^
Discard the bolt.
^
To install, tighten the new bolt to 30 Nm (22 ft. lbs.).
10. Remove the 4 brake pedal bracket nuts and brake pedal and bracket.
^
To install, tighten to 28 Nm (21 ft. lbs.).
11. CAUTION: The brake switch must be positioned with the closed hole away from the brake pedal arm and the open hole toward the brake
pedal arm or damage to the switch may occur.
CAUTION: Do not press, pull or otherwise move the brake pedal while installing the speed control deactivator switch. This switch must
be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position. Installing this switch
with the brake pedal in any other position will result in incorrect adjustment and may damage the switch.
To install, reverse the removal procedure.
^
Verify correct stoplight operation.
12. CAUTION: The adjustable pedal system must be indexed whenever the brake pedal assembly or the accelerator pedal assembly is
serviced or component damage may occur.
Index the adjustable pedal system.
