Crown Victoria V8-4.6L Flex Fuel (2008)
Remove the 2 brake caliper bolts and position the caliper aside.
^
Support the brake caliper using mechanic's wire.
^
To install, tighten to 25 Nm (18 ft. lbs.).
4. CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the brake pads.
Remove the brake pads.
5. CAUTION: Protect the piston and boots when pushing the caliper piston into the caliper piston bores or damage to the piston or boot
may occur.
If installing new brake pads, using a suitable tool and a worn brake pad, compress the disc brake caliper pistons into the caliper.
6. To install, reverse the removal procedure.
^
Fill the master cylinder with clean specified fluid.
^
Make sure the anti-rattle clips are clean and in good condition.
^
Test the brake system for normal operation.
7. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
