Crown Victoria V8-4.6L Flex Fuel (2008)
10. Press the retaining tabs and disconnect the front parking brake cable conduit from the parking brake control bracket.
11. Remove the front parking brake cable bracket bolt.
^
To install, tighten to 12 Nm (9 ft. lbs.)
12. Disconnect the front parking brake cable from the parking brake control.
13. Push the front parking brake conduit grommet through the body and remove the front parking brake cable.
14. To install, reverse the removal procedure.
^
Adjust the parking brake cable tension. For additional information, refer to Parking Brake Cable Adjustment.
15. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
16. If equipped, turn the air suspension service switch to the ON position.