Crown Victoria V8-4.6L Flex Fuel (2008)
19. Disconnect the parking brake release vacuum hose from the parking brake release control motor, if equipped.
20. Disconnect the parking brake switch electrical connector.
21. Disconnect the front parking brake cable and conduit from the parking brake control.
22. Remove the 3 parking brake control bolts.
^
To install, tighten to 30 Nm (22 ft. lbs.)
23. Remove the parking brake control.
24. To install, reverse the removal procedure.
^
Adjust the parking brake cable tension.
25. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
26. If equipped, turn the air suspension service switch to the ON position.
