Crown Victoria V8-4.6L Flex Fuel (2008)
Removal and Installation
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire
Suppression System. Failure to follow the instructions may result in serious personal injury.
Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding.
2. Remove the bolt and position aside the power steering reservoir.
^
To install, tighten to 10 Nm (89 inch lbs.).
3. Disconnect the degas bottle overflow hose and the supply hose and position aside.
4. Remove the bolt and the degas bottle.
^
To install, tighten to 10 Nm (89 inch lbs.).
5. Disconnect the upper radiator hose and position aside.
6. Detach the transmission cooler tubes from the cooling fan motor and shroud.
7. Disconnect the cooling fan motor and shroud electrical connector.
8. NOTE: Position the lower radiator hose away from the cooling fan motor and shroud.
Remove the 2 bolts and the cooling fan motor and shroud assembly.
^
To install, tighten to 10 Nm (89 inch lbs.).
9. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
10. Fill and bleed the cooling system.
