Crown Victoria V8-4.6L Flex Fuel (2008)
^
Discard the O-ring seal.
^
To install, tighten to 25 Nm (18 ft. lbs.).
6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
CAUTION: Do not rotate the coolant pump housing once installed in the engine. Damage to the O-ring seal can occur, causing the
coolant pump to leak.
NOTE: Install a new O-ring seal and lubricate with the clean engine coolant.
To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
7. Fill and bleed the cooling system.
