Crown Victoria V8-4.6L Flex Fuel (2008)
5. Remove the oil filter and discard.
^
Lubricate the new oil filter O-ring seal with clean engine oil prior to installation.
6. Remove the LH and RH lower engine mount nuts.
^
To install, tighten to 90 Nm (66 ft. lbs.).
7. Using the special tool, raise the engine.
8. Remove the 3 bolts and the LH engine mount.
^
To install, tighten to 70 Nm (52 ft. lbs.).
9. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
Engine Mount - RH
Engine Mount - RH
