Crown Victoria V8-4.6L Flex Fuel (2008)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
1. Remove the air cleaner. For additional information, refer to Fuel Delivery and Air Induction.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Disconnect the ABS module electrical connector.
4. Disconnect the hydraulic control unit (HCU) pump motor electrical connector.
5. NOTE: Care must be taken when removing the module from the HCU.
Remove the ABS module.
^
Remove the screws in the sequence shown.
^
To install, tighten to 3 Nm (27 inch lbs.).