Crown Victoria V8-4.6L Flex Fuel (2008)
Air Bag Control Module: Service and Repair
RESTRAINTS CONTROL MODULE (RCM)
Removal
WARNING:
-
If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for
deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed
whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
-
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious
personal injury or death.
-
Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do
so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraints system (SRS) fault.
-
When installing a new RCM, always make sure the correct RCM is being installed. If an incorrect RCM is installed, erroneous DTCs will result.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
Vehicles with floor shifter
1. Apply the parking brake and place the transmission in position 1.
All vehicles
