Crown Victoria V8-4.6L Flex Fuel (2008)
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
The front center safety belt and tongue is mounted on the driver seat inboard rear mounting stud. Removal of the front center safety belt buckle is
similar to the front center safety belt and tongue. The front center safety belt and tongue is shown.
All seats
1. Position the seat to access the fasteners.
Seats with side air bags
2. Depower the SRS.
All seats
3. Remove the 2 seat track front covers.
4. Remove the 2 seat track front bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
5. Remove the 2 seat track rear covers.
6. Remove the 2 seat track rear nuts.
-
To install the inboard nut, tighten to 80 Nm (59 lb-ft).
-
To install the outboard nut, tighten to 25 Nm (18 lb-ft).
7. Tilt the seat forward enough to separate the front center safety belt and tongue anchor from the mounting stud and seat.
8. Route the safety belt and tongue through the seat cushion opening and remove the assembly.
9. NOTE:
-
When installing, make sure the safety belt anchor is in place on the rear inboard stud before tightening the nut.
-
Make sure the safety belt and tongue or safety belt buckle are accessible to the passenger after installation.
-
Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
Seats with side air bags
10. Repower the SRS.
All seats
11. Check the active restraints for correct operation.
