Crown Victoria V8-4.6L Flex Fuel (2008)
All seats
10. Align the seat cushion trim cover to the seat cushion pad and fasten the hook-and-loop strips.
11. Position the seat cushion trim cover and attach the J-clips.
Seats with power lumbar
12. Connect the power lumbar switch electrical connector.
13. Attach the power lumbar switch and bezel to the seat.
Seats with manual recline
14. Install the seat backrest recliner handle.
Heated seats
15. Connect the cushion heated seat element electrical connector.
All seats
16. Install the seat track.
17. Install the front seat backrest.
18. Install the front seat.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
19. Repower the SRS. Do not prove out the system at this time.
20. WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
It is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger seat cushion is disassembled,
a new trim cover installed or an OCS service kit is installed. A scan tool is used to trigger the active command to carry out the OCS
system reset.
-
Make sure the seat is completely assembled to prevent system failure before carrying out the occupant classification sensor (OCS)
system reset active command.
-
The following precautions must be taken before carrying out the occupant classification sensor (OCS) system reset.
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the OCS system is not at a temperature below 0°C (32°F) or above 45°C (113°F) when initiating the OCS system reset
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a
temperature within the limits, 0°C to 45°C (32°F to 113°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat
during the process.
-
Make sure a minimum 8 second time period has passed after cycling the ignition switch ON before carrying out the OCS system
