Crown Victoria V8-4.6L Flex Fuel (2008)
Suspension Control Module: Service and Repair
Air Suspension Module
Air Suspension Module
Removal and Installation
WARNING: Shut off the electrical power to the air suspension system prior to hoisting or jacking an air suspension equipped vehicle. Failure
to do so may result in unexpected inflation or deflation of the air springs, which may result in shifting of the vehicle during these operations.
Failure to follow this instruction may result in serious personal injury.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
CAUTION: Suspension fasteners are critical parts because they effect performance of vital components and systems and their failure can
result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. Turn the air suspension service switch to the OFF position.
2. Disconnect the battery ground cable.
3. While pushing in on the 2 glove compartment door tabs, position the glove compartment downward.
4. Remove the air suspension module in the following sequence.
1. Disconnect the 2 electrical connectors.
2. Disconnect the module from the bracket.
3. Remove the air suspension module.
5. To install, reverse the removal procedure.
