Crown Victoria V8-4.6L Flex Fuel (2008)
2. Install the upper ball joint nut and tighten to 150 Nm (111 lb-ft).
3. Attach the wheel speed sensor wiring harness to the wheel knuckle.
4. Position the stabilizer bar link and install the 2 nuts.
^
Tighten the lower nut to 55 Nm (41 lb-ft).
^
Tighten the upper nut to 63 Nm (46 lb-ft).
5. Install the brake disc.
6. Position the brake caliper and anchor plate assembly and install the 2 anchor plate bolts.
^
Tighten to 160 Nm (118 lb-ft).
7. Install the wheel and tire.
8. Install the 3 shock absorber upper mount nuts.
^
Tighten to 30 Nm (22 lb-ft).
9. With the weight of the vehicle on the wheel and tire assemblies, tighten the shock absorber lower nut to 235 Nm (173 lb-ft).
10. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
Rear
Spring - Coil
Spring - Coil
Removal
CAUTION: Suspension fasteners are critical parts because they affect the performance of vital components and their failure may result in
