Crown Victoria V8-4.6L Flex Fuel (2008)
6. Position the mounting bracket and dust boot onto the spring. Make sure the marks made during Disassembly, Step 3, are lined up.
7. Install a new shock rod nut.
^
To install, tighten to 50 Nm (37 lb-ft).
8. Remove the spring compressor.
9. Install the shock absorber and spring assembly.
10. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
