Crown Victoria V8-4.6L Flex Fuel (2008)
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct
retention of these parts.
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire
Suppression System. Failure to follow the instructions may result in serious personal injury.
Remove the wheel and tire.
2. CAUTION: Do not allow the caliper and anchor plate to hang from the brake hose or damage to the hose may occur.
Remove the bolts and position the caliper and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 160 Nm (118 lb-ft).
3. Remove the brake disc.
4. Peel back the rubber splash shield and disconnect the wheel speed sensor electrical connector.
5. Remove the bolts and the wheel bearing and wheel hub.
^
To install, tighten to 120 Nm (89 lb-ft).
6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
CAUTION: To avoid sensor or wiring damage, be sure to correctly route the wheel speed sensor wiring in front of the stabilizer bar link.
NOTE: During reassembly, verify that the wheel speed sensor electrical connector is fully seated with an audible click, and that the rubber splash
shield is positioned back into place.
To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
