Crown Victoria V8-4.6L Flex Fuel (2008)
2. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align all the index marks and position the driveshaft on the transmission.
^
Install the driveshaft.
3. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the 4 retaining bolts.
^
Tighten to 103 Nm (76 lb-ft).
4. Check the level of the transmission fluid, add clean automatic transmission fluid as necessary.
