ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Selector Lever Cable and Bracket - Column Shift|Page 3469 > < Selector Lever Cable and Bracket - Column Shift
Page 2
background image

If equipped, turn the air suspension switch to the OFF position.

2. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire

Suppression System. Failure to follow the instructions may result in serious personal injury.

With the vehicle in NEUTRAL, position it on a hoist.

3. Disconnect the selector lever cable from the transmission.

1. Remove the nut and disconnect the selector lever cable from the manual control lever.
2. Disconnect the selector lever cable from the selector lever cable bracket.
3. Remove and discard the selector lever cable retainer.

4. Unclip the selector lever cable from the clips that route the cable upward toward the top of the engine compartment.
5. Remove the bolts and the selector lever cable bracket from the transmission.

6. From the engine compartment, unclip the selector lever cable from the clip that routes the cable toward the bulkhead.
7. Disconnect the selector lever cable from the steering column.

1. Disconnect the selector lever cable from the transmission selector lever arm and support.
2. Disconnect the selector lever cable from the steering column bracket.
3. Remove and discard the selector lever cable retainer.

8. From the engine compartment, use a suitable tool to push the rubber grommet through the bulkhead.
9. From the passenger compartment, remove the selector lever cable from the vehicle.

 

Selector Lever Cable and Bracket - Column Shift|Page 3469 > < Selector Lever Cable and Bracket - Column Shift