Crown Victoria V8-4.6L Flex Fuel (2008)
4. Press on the spider to remove the bearing cup from the opposite side.
5. Remove the driveshaft slip yoke.
7. Remove the remaining bearing cups and the spider.
8. Remove the snap rings from the driveshaft centering socket yoke end.
9. NOTE: If the bearing cup cannot be pressed all the way out, remove it with vise grips.
Remove the driveshaft centering socket yoke.
1. Position the driveshaft in the special tool.
2. Press out a bearing cup.
3. Rotate the driveshaft 180 degrees.
4. Press on the spider to remove the bearing cup from the opposite side.
5. Remove the driveshaft centering socket yoke.
10. Remove the remaining bearing cups and the spider.
11. Clean the driveshaft yoke area at each end of the driveshaft.
^
Inspect the driveshaft and driveshaft components for wear or damage.
Assembly
NOTE: U-joint service kits are to be installed as complete assemblies only. Do not use components from other U-joints.
1. Install a new bearing cup.
