Crown Victoria V8-4.6L SOHC VIN W (2005)
4. Install the rear wheel brake hose.
^
Connect the brake hose and install the caliper flow bolt.
-
Use new copper washers.
5. Bleed the brake system.
6. NOTE: After the vehicle is on the ground, if equipped with air suspension, reactivate the system by turning on the air suspension switch.
Install the wheel and tire assembly.
7. NOTE: Apply the brakes several times before driving the vehicle.
Verify correct brake operation.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal and Installation
1. Disconnect the rear parking brake cable and conduit.
2. Remove the axle shaft.
3. WARNING: To avoid injury when using air tools, do not hold flag nuts with fingers. Failure to follow these instructions may result in
personal injury.
Remove the bolts and the rear wheel disc brake caliper anchor plate.
4. To install, reverse the removal procedure.
