Crown Victoria V8-4.6L SOHC VIN W (2005)
Fuel Rail: Service and Repair
FUEL RAIL
Removal
WARNING:
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions can result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before servicing or disconnecting any of the fuel
system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire
hazard.
1. Disconnect the battery ground cable.
2. Release the fuel system pressure.
3. Disconnect the fuel tubes.
4. Remove the throttle body (TB).
5. Remove the exhaust gas recirculation (EGR) system module to exhaust manifold tube.
6. Remove the accessory drive belt.
7. Disconnect the generator cable, the electrical connector and the harness pin-type retainer.
8. Remove the bolts and the generator mounting bracket.
9. Separate the fuel charging wiring pin-type retainer from the crash bracket.