Crown Victoria V8-4.6L SOHC VIN W (2005)
18. Remove the four retaining studs (two shown).
19. Remove the fuel rail and the fuel injectors as an assembly.
20. Separate the fuel injectors from the fuel rail.
-
Discard the O-ring seals.
Installation
1. CAUTION: Use O-rings seals that are made of special fuel-resistant material. Use of ordinary O-ring seals can cause the fuel system to
leak. Do not reuse O-ring seals.
Lubricate the fuel injectors with clean engine oil and install in the fuel rail.
2. Install the fuel rail and the fuel injectors as an assembly.
3. Install the fuel rail studs.
-
Tighten to 10 Nm (89 lb-in).
4. Install the crash bracket.
5. Install the bolt and the stud.
