Crown Victoria V8-4.6L SOHC VIN W (2005)
Differential Cover: Service and Repair
Differential Housing Cover
Material
Removal
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the LH side of the luggage compartment. Failure to
do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle. Refer to Maintenance/Service and Repair.
2. Remove the differential housing cover.
1
Remove the bolts and drain the lubricant from the differential housing.
2
Remove the differential housing cover.
Installation
1. CAUTION: The machined surfaces on the differential housing and the differential housing cover must be clean and free of oil before applying
the silicone sealant. Cover the inside of the rear axle prior to cleaning the machined surface to prevent contamination.
Clean the gasket mating surfaces.
2. CAUTION: Install the differential housing cover within 15 minutes of applying the silicone, or it will be necessary to apply new sealant.
