Crown Victoria V8-4.6L SOHC VIN W (2005)
3
Install the special tool into the replacer tools.
2. Tighten the special tool to seat the differential drive pinion bearing cups into their bores.
3. NOTE: This step and the following step are alternate methods for installing the differential drive pinion bearing cups. Carry out these two steps if
differential drive pinion bearing cup installation was not done in the previous steps.
Using the special tools, drive the outer differential drive pinion bearing cup into the differential housing.
4. Using the special tools, drive the inner differential drive pinion bearing cup into the differential housing.
5. CAUTION: Always install new differential pinion bearings when installing new differential drive pinion bearing cups.
NOTE: If the feeler gauge can fit between a cup and the bottom of its bore at any point around the cup, remove and reseat the cup.
