Crown Victoria V8-4.6L SOHC VIN W (2005)
3. Remove the driveshaft from the special tool and install the snap ring.
4. CAUTION: Do not apply excessive pressure causing the opposite snap ring to damage the snap ring groove.
Repeat for the opposite side.
5. Install a new bearing cup.
1
Start a new bearing cup into the driveshaft centering socket yoke.
2
Install the driveshaft into the special tool.
3
Press the bearing cup below the yoke surface.
6. Remove the driveshaft from the special tool and install the snap ring.
7. Repeat Steps 5 and 6 for the opposite side.
8. NOTE: Do not strike the bearings. If binding, strike the yoke with a brass or plastic hammer.
