Crown Victoria V8-4.6L VIN W (2000)
Antenna Cable: Service and Repair
Antenna Lead In, Rear Cable
REMOVAL
CAUTION: The antenna lead-in cable is not removable from the wiring harness. If the cable needs to be replaced, leave it in the wiring harness. Install
a new cable on top of the body main wiring harness and secure it with wire ties. Do not cut into the wiring harness to remove the existing antenna lead-in
cable.
1. Disconnect the battery ground cable.
2. Remove the package tray trim panel.
3. Remove the roof side rear trim panels.
4. Remove the RH front and rear scuff plates.
NOTE: RH front shown, all others similar.
5. Remove the lower quarter trim panel.
6. Remove the B-pillar trim panel.
