Crown Victoria V8-4.6L VIN W (2000)
Keyless Entry Transmitter: Service and Repair
Programming Transmitter
1. Cycle the ignition from OFF to RUN four times within three seconds. The locks will then lock and unlock, confirming program mode has been
entered.
NOTE: Keyless entry remote transmitters can also be programmed using a scan tool and the Ford Service Function (FSF) card.
2. Press any button on the transmitter to be programmed.
NOTE: When the first keyless entry remote transmitter is programmed, all other keyless entry remote transmitters are erased.
3. If additional keyless entry remote transmitters are to be programmed, repeat Step 2 within 7.5 seconds.
4. To exit program mode, turn the ignition to START or wait 7.5 seconds.