Crown Victoria V8-4.6L VIN W (2000)
Multifunction Electronic Control Modules: Service and Repair
Lighting Control (LCM) Module
REMOVAL
1. Disconnect the battery ground cable.
CAUTION:
^
Prior to removal of module, it is necessary to upload module configuration information to New Generation STAR (NGS) Tester. This
information needs to be downloaded into the new module once installed. For additional information; refer to Module Communications
Network (Information Bus).
^
Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
2. Remove the LH instrument panel lower insulator.
1
Remove the pin-type retainers.
2
Disconnect the courtesy lamp.
3
Remove the LH instrument panel insulator.
3. Position the LCM aside.
1
Remove the screws.
2
Release the locking tab.
3
Position the LCM aside.
4. Remove the LCM.
1
Disconnect the electrical connectors.
2
Remove the LCM.
