Crown Victoria V8-4.6L VIN W (2000)
Timing Chain Tensioner: All Technical Service Bulletins
Engine - Timing Chain Grinding Noise
Article No.
03-15-7
08/04/03
^
ENGINE - 4.6L - GRINDING TYPE NOISE FROM
ENGINE TIMING CHAIN AREA
^
NOISE - GRINDING TYPE NOISE FROM ENGINE TIMING
CHAIN AREA
FORD:
2000-2003 CROWN VICTORIA
MERCURY:
2000-2003 GRAND MARQUIS
ISSUE
Some 4.6L 2V engines may exhibit a grinding type noise from the timing chain area. This may be caused by excessive wear of the timing chain tensioner
arms. The tensioner arm has an aluminum base with a nylon surface. Another indication of this condition may be fine nylon and/or aluminum particles
present in the engine oil.
ACTION
Inspect the timing chain and arms to determine if excessive wear exists. If this condition is present, replace the timing chains, tensioners and the
tensioner arms. Refer to the following Service Information for details.
SERVICE INFORMATION
Refer to Workshop Manual Section 303-01A for correct replacement service procedures.
^
Fine finish timing chains - part F5LY-6268-A
^
Tensioner - 2000 RH part F6AZ-6L266-DA, LH part F6AZ-6L266-CA
^
Tensioner - 2001-2003 RH part 1L3Z-6L266-AA, LH part XL1Z-6L266-AA
^
Tensioner arms - LH part 1L2Z-6L253-AA, RH part 1L2Z-6L253-BA
Remove residual nylon/aluminum particles by performing an engine oil change and replacing the oil filter. If wear has progressed through tensioner arm
into tensioner piston, remove oil pan from engine and clean debris from oil pick up tube.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
Disclaimer
