Crown Victoria V8-4.6L VIN W (2000)
3.
Inspect the Brake Pedal Position Switch electrical connector (2000/2001 - C2002: 2002 - C278) for deformation. Refer to Wiring Diagrams,
Section 90 for additional details.
4.
If no deformation is found, refer to Workshop Manual, Sections 307-05 & 417-01, for normal diagnostic information.
5.
If deformation is found, continue with the following procedure.
6.
Disconnect the battery ground cable.
7.
Disconnect the Brake Pedal Position Switch electrical connector.
8.
Remove the deformed connector by cutting off 4 inches of wire from the harness.
9.
Strip approximately 1/4" from the remaining harness and twist the end of each wire.
10.
Obtain the repair kit part number 2W1Z-14A411-AAA.
11.
The repair kit pigtail wiring comes in 1 piece with connectors.
12.
Strip approximately 1/4" of insulation from the repair pigtail and twist the end of each wire.
13.
Since the switch is polarity sensitive, match evenly the wire color (LG light green to LG, LG/RD light green with red strip with LG/RD).
14.
Use crimp connectors that are found in the repair kit.
15.
Evenly position the crimp connectors over the wire repair.
16.
To crimp the connectors, use the proper wire crimp tool.
17.
Use a heat gun to heat the repaired area until adhesive flows out of both ends of the heat shrink.
18.
Reconnect the Brake Pedal Position Switch.
19.
Replace the LH instrument panel insulator.
20.
Reconnect battery ground cable.
21.
Test and verify the Brake Pedal Position Switch operates properly.
