Crown Victoria V8-4.6L VIN W (2000)
8.
Twist the ends of the diode wires around the exposed wire on circuits 57 and 321 (Figure 3).
9.
Solder the diode wires to circuits 57 and 321. Use rosin core mildly activated (RMA) solder.
DO NOT USE ACID CORE SOLDER
10.
Slip Dual Wall Heat Shrink Tubing (Motorcraft part # WT-5627-A) containing hot melt wax up the terminal ends of circuits 57 and 321 over the
exposed wire.
NOTE
IT IS IMPORTANT TO USE HEAT SHRINK TUBING CONTAINING HOT MELT WAX OVER A SOLDERED CIRCUIT JOINT TO
CREATE A WATERPROOF AND AIRTIGHT CONNECTION. MAKE SURE THAT THE TUBING COVERS ALL EXPOSED WIRES
PLUS AT LEAST A HALF INCH AT BOTH ENDS (FIGURE 4).