Crown Victoria V8-4.6L VIN W (2000)
15. Install the ECS module fuses F18 (10A) and F10 (10A) to the CJB.
16. Connect the battery ground cable.
Reactivation
1. Remove the ECS module fuses F18 (10A) and F10 (10A) from the central junction box (CJB).
2. Disconnect the battery ground cable and wait at least one minute.
3. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger air bag module electrical connector and connect the
passenger air bag module electrical connector.
4. Connect the glove compartment isolator.
5. Close the glove compartment door.
6. Remove the restraint system diagnostic tool from the clockspring electrical connector at the top of the steering column.
7. Connect and position the driver air bag module.
1. Connect the driver air bag module electrical connector.
2. Connect the horn switch electrical connector.
3. Position the driver air bag module to the steering wheel.
8. Install the two driver air bag module bolts (one shown).
9. Install the steering wheel two back cover plugs.
10. Turn the ignition switch from OFF to ON.
11. Install the ECS module fuses F18 (10A) and F10 (10A) to the CJB and install the cover.
Warning: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the battery
ground cable is connected.
12. Connect the battery ground cable.
13. Prove out the supplemental restraint system (SRS) as follows: Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to
ON and visually monitor the air bag indicator with the air bag modules installed. The air bag indicator will light continuously for approximately
six seconds and then turn off. If an air bag supplemental restraint system (SRS) fault is present, the air bag indicator will either:
