Crown Victoria V8-4.6L VIN W (2000)
Brake Pedal Position Switch: Service and Repair
REMOVAL
1
Disconnect the battery ground cable.
2. Remove LH instrument panel insulator.
1
Remove the pin-type retainers.
2
Remove the LH instrument panel insulator.
^
Disconnect the courtesy lamp.
3. Disconnect the Brake Pedal Position (BPP) switch electrical connector.
4. Remove the BPP switch.
1
Remove the self-locking pin.
2
Remove the (A) BPP switch from the (B) brake master cylinder push rod.
3
Remove the brake master cylinder push rod spacer.
4
Remove the brake master cylinder push rod bushing.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
