Crown Victoria V8-4.6L VIN W (2000)
Turn Signal Switch: Service and Repair
Removal
Multifunction Switch
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
1
Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2
Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. Remove the tilt wheel handle and shank.
4. Remove the upper and lower steering column shrouds.
1
Remove the screws.
2
Remove the shrouds.
5. Remove the multifunction switch.
