Crown Victoria V8-4.6L VIN W (2000)
The side air bag sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary batteries
and power supplies (if equipped).
1. Disconnect the battery ground cable and wait at least one minute.
2. Remove the steering wheel.
3. Twist off the cap from the ignition switch lock cylinder.
4. Remove the ignition switch lock cylinder.
^
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
^
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
^
Remove and discard the ignition switch lock cylinder and drill shavings from the steering column.
5. Remove the bearing retainer.