Crown Victoria V8-4.6L VIN W (2000)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley
Removal
Removal
1. Remove the drive belt.
2. Raise the vehicle.
3. CAUTION: Do not apply pressure on the power steering pump rotor shaft. Pressure will damage internal thrust areas of the power steering pump.
Use the special tool to remove the pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
Installation
Installation
1. CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.
Use the special tool to install the power steering pump pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
2. Lower the vehicle.
3. Install the drive belt.