Crown Victoria V8-4.6L VIN W (2000)
7. Note: Reset the steering gear meshload only if the measured rotating torque for total on-center load is less than specification.
Attach a torque wrench to the (A) bolt and measure the steering gear meshload from center.
8. Meshload adjustment is necessary if out of specification.
9. Adjust the sector shaft to proper rotating torque.
1
Hold the sector shaft and loosen the meshload adjuster locknut.
2
Adjust the sector shaft.
10. Verify that the rotating torque is to specification.
^
Readjust if necessary.
