E 100 Van V8-351 5.8L (1982)
Lower Side Moulding / Trim: Technical Service Bulletins
Body - Spot Weld Marks On Side Panels
Article No. 85-6-15
SHEET METAL - SPOT WELD MARKS ON BODY SIDE PANELS
LIGHT TRUCK 1980-85 ECONOLINE
Spot weld marks along the lower body side panels at the character line of Econoline vehicles may affect appearance or customer satisfaction.
This condition can be resolved with the installation of a 24mm wide adhesively attached body side molding kit now available as a service kit. The
moldings are applied along the character line from the rear of the front fender to the rear of the vehicle. This service only kit is pre-cut, and requires only
cleaning the surface of all wax and dirt, peeling the plastic backing from the molding and applying the molding in the designated area. The body side
molding kit is designed to fit both the 124 inch and 138 inch wheelbase units with either sliding or cargo side doors.
PART NUMBER
PART NAME
CLASS
E5UZ-2221048-A
Body Side Molding Kit
BA
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: "INFORMATION ONLY"
